DOORFRAMER's Bottom Strap

Secures jamb and door when no sill is attached. Recommend one staple on side of jamb and two into the door bottom

* Provides cost savings over all existing techniques  or products.
* Helps maintain reveal around the door.
* Holds the door shut during shipping.
* Protects bottom corners and provides skid plate.
* Gives the corner joint additional support.
* Can be removed using conventional tools.
* Prevents chattering, protecting head joint integrity.

DOORFRAMER's Bottom Skid is designed to protect the jamb from chipping and to make the door easier to slide.  It's intended for use with both interior and exterior doors from  the point of manufacture to the point of installation.  The Bottom Skid is secured by stapling to the jamb.

* Protects  jamb from damage during shipping and handling.
* Easy to install - can either be stapled from side into jamb or into specially designed indentations on the bottom into the bottom of the jamb.
* Allows the installer an easy, gliding motion for moving the door.
* Sleek continuous design reduces chance of part being dislodged by rough floors, wire racks or rollers.
* A cost effective alternative to cardboard or corrugated plastic.
* Can be installed on head  jamb for easy movement when door is inverted.

DOORFRAMER's Lift Handles are used to make the movement of doors easier. Typically used for exterior, sidelight and double doors, Lift Handles can also be used for heavier interior doors. Lift Handles are attached to the side jambs about  30" from the bottom.  Six to eight screws are recommended.